862 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
AUTHENTICATION COMMANDS
AUTH
REAUTHENTICATION
auth reauthentication
Overview This command enables re-authentication on the interface specified in the Interface
mode, which may be a static channel group (or static aggregator) or a dynamic (or
LACP) channel group or a switch port.
Use the no variant of this command to disables reauthentication on the interface.
Syntax
auth reauthentication
no auth reauthentication
Default Reauthentication of port authentication is disabled by default.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port.
Examples To enable reauthentication on interface port1.0.2, use the following
commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# auth reauthentication
Validation
Commands
show dot1x
show dot1x interface
show running-config
To Next Page
Loading...
