Allied Telesis AlliedWare Plus AT-x230-10GP - Show Ipv6 Route

C613-50055-01 REV A Command Reference for x230 Series Edge Switches 587
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
IPV6 COMMANDS
SHOW
IPV6 ROUTE
show ipv6 route
Overview Use this command to display the IPv6 routing table for a protocol or from a
particular table.
For information on filtering and saving command output, see “Controlling “show”
Command Output” in the “Getting Started with AlliedWare Plus” Feature Overview
and Configuration Guide.
Syntax
show ipv6 route
[connected|database|static|summary|<ipv6-address>|<ipv6-addr/p
refix-length>)]
Mode User Exec and Privileged Exec
Example 1 To display an IP route with all parameters turned on, use the following command:
awplus# show ipv6 route
Output Figure 16-3: Example output of the show ipv6 route command
Parameter Description
connected Displays only the routes learned from connected
interfaces.
database Displays only the IPv6 routing information extracted
from the database.
static Displays only the IPv6 static routes you have configured.
summary Displays summary information from the IPv6 routing
table.
<ipv6-address> Displays the routes for the specified address in the IP
routing table. The IPv6 address uses the format
X:X::X:X/Prefix-Length. The prefix-length is usually set
between 0 and 64.
<ipv6-prefix/length> Displays only the routes for the specified IP prefix.
IPv6 Routing Table
Codes: C - connected, S - staticS ::/0 [1/0] via
2001::a:0:0:c0a8:a6, vlan10
C 2001:db8::a:0:0:0:0/64 via ::, vlan10
C 2001:db8::14:0:0:0:0/64 via ::, vlan20
C 2001:db8::0:0:0:0/64 via ::, vlan30
C 2001:db8::28:0:0:0:0/64 via ::, vlan40
C 2001:db8::fa:0:0:0:0/64 via ::, vlan250
C 2001:db8::/64 via ::, vlan250
C 2001:db8::/64 via ::, vlan40
C 2001:db8::/64 via ::, vlan20
C 2001:db8::/64 via ::, vlan10