C613-50055-01 REV A Command Reference for x230 Series Edge Switches 511
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
POWER OVER ETHERNET COMMANDS
POWER
-INLINE ALLOW-LEGACY
power-inline allow-legacy
Overview This command enables detection of pre-IEEE 802.3af Power Ethernet standard
legacy Powered Devices (PDs).
The no variant of this command disables detection of pre-IEEE 802.3af Power
Ethernet standard legacy Powered Devices (PDs).
Syntax
power-inline allow-legacy
no power-inline allow-legacy
Default Detection of legacy PDs is enabled on all ports on the Power Sourcing Equipment
(PSE).
Mode Global Configuration
Examples To disable detection of legacy PDs, use the following commands:
awplus# configure terminal
awplus(config)# no power-inline allow-legacy
To enable detection of legacy PDs, use the following commands:
awplus# configure terminal
awplus(config)# power-inline allow-legacy
Validation
Commands
show power-inline
show running-config power-inline
To Next Page
Loading...
Need help?
General
