Allied Telesis AlliedWare Plus AT-x230-10GP - Mls Qos Enable

778 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
QOS COMMANDS
MLS
QOS ENABLE
mls qos enable
Overview Use this command to globally enable QoS on the switch.
Use the no variant of this command to globally disable QoS and remove all QoS
configuration. The no variant of this command removes all class-maps,
policy-maps, and policers that have been created. Running the no mls qos
command will therefore remove all pre-existing QoS configurations on the switch.
Mode Global Configuration
Syntax
mls qos enable
no mls qos
Example To enable QoS on the switch, use the commands:
awplus# configure terminal
awplus(config)# mls qos enable