C613-50055-01 REV A Command Reference for x230 Series Edge Switches 1245
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
AMF COMMANDS
SHOW
ATMF AREA NODES-DETAIL
show atmf area nodes-detail
Overview Use this command to display detailed information about an AMF controller’s
remote nodes.
Syntax
show atmf area nodes-detail [<area-name>] [<node-name>]
Mode Privileged Exec
Usage If you do not limit the output to a single area or node, this command displays
information about all remote nodes that the controller is aware of. This can be a
very large number of nodes.
Example To show information about all the nodes the controller is aware of, use the
command:
controller-1# show atmf area nodes-detail
Parameter Description
<area-name> Displays detailed information about nodes in the specified area.
<node-name> Displays detailed information about the specified node.
To Next Page
Loading...
