C613-50055-01 REV A Command Reference for x230 Series Edge Switches 1311
AlliedWare Plusâ„¢ Operating System - Version 5.4.5-0.x
NTP COMMANDS
SHOW
COUNTER NTP
show counter ntp
Overview This command displays packet counters for NTP.
Syntax
show counter ntp
Mode User Exec and Privileged Exec
Output Figure 37-1: Example output from the show counter ntp command
NTP counters
Pkts Sent ......... 0
Pkts Received ......... 70958
Pkts Processed ......... 0
Pkts current version ......... 0
Pkts old version ......... 0
Pkts unknown version ......... 0
Pkts access denied ......... 70958
Pkts bad length ......... 0
Pkts bad auth ......... 0
Pkts rate exceed ......... 0
Table 37-1: Parameters in the output from the show counter ntp command
Parameter Description
Pkts Sent Total number of NTP client and server packets sent by your
device.
Pkts Received Total number of NTP client and server packets received by your
device.
Pkts Processed The number of packets processed by NTP. NTP processes a
packet once it has determined that the packet is valid by
checking factors such as the packet’s authentication, format,
access rights and version.
Pkts current
version
The number of version 4 NTP packets received.
Pkts old
version
The number of NTP packets received that are from an older
version, down to version 1, of NTP. NTP is compatible with these
versions and processes these packets.
Pkts unknown
version
The number of NTP packets received that are an earlier version
than version 1, or a higher version than version 4. NTP cannot
process these packets.
Pkts access
denied
The number of NTP packets received that do not match any
access list statements in the NTP access-groups. NTP drops
these packets.
To Next Page
Loading...
Need help?
General
