Allied Telesis AlliedWare Plus AT-x230-10GP - Show Auth-Mac Supplicant Interface

C613-50055-01 REV A Command Reference for x230 Series Edge Switches 927
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
AUTHENTICATION COMMANDS
SHOW
AUTH-MAC SUPPLICANT INTERFACE
show auth-mac supplicant interface
Overview This command shows the supplicant (client device) state for the MAC
authenticated interface, which may be a static channel (or static aggregator) or a
dynamic (or LACP) channel group or a switch port. This command shows a
summary when the optional brief parameter is used.
Syntax
show auth-mac supplicant [interface <interface-list>] [brief]
Mode Privileged Exec
Examples To display the MAC authenticated supplicant on the interface port1.0.2, enter
the command:
awplus# show auth-mac supplicant interface port1.0.2
Parameter Description
interface Specify ports to show.
<interface-list> The interfaces or ports to configure. An interface-list can be:
•an interface (e.g. vlan2), a switch port (e.g. port1.0.6),
a static channel group (e.g. sa2) or a dynamic (LACP)
channel group (e.g. po2)
• a continuous range of interfaces, ports, static channel
groups or dynamic (LACP) channel groups separated by a
hyphen; e.g. vlan2-8, or port1.0.1-1.0.4, or sa1-2,
or po1-2
• a comma-separated list of the above; e.g.
port1.0.1,port1.0.4-1.0.6. Do not mix interface
types in a list
The specified interfaces must exist.
brief Brief summary of the supplicant state.