C613-50055-01 REV A Command Reference for x230 Series Edge Switches 1275
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
AMF COMMANDS
SHOW
ATMF PROVISION NODES
show atmf provision nodes
Overview This command displays information about each provisioned node with details
about date and time of creation, boot and configuration files available in the
backup, and license files present in the provisioned backup. This includes nodes
that have joined the network but are yet to run their first backup.
This command can only be run on AMF master and controller nodes.
Syntax
show atmf provision nodes
Mode Privileged Exec
Usage This command will only work if provisioned nodes have already been set up.
Otherwise, an error message is shown when the command is run.
Example To show the details of all the provisioned nodes in the backup use the command:
NodeName# show atmf provision nodes
Figure 35-11: Sample output from the show atmf provision nodes command
Related
commands
atmf provision node create
atmf provision node clone
atmf provision node configure boot config
atmf provision node configure boot system
show atmf backup
device1#show atmf provision nodes
ATMF Provisioned Node Information:
Backup Media .............: SD (Total 3827.0MB, Free 3481.1MB)
Node Name : device2
Date & Time : 06-May-2014 & 23:25:44
Provision Path : card:/atmf/provision_nodes
Boot configuration :
Current boot image : x510-1766_atmf_backup.rel (file exists)
Backup boot image : x510-main-20140113-2.rel (file exists)
Default boot config : flash:/default.cfg (file exists)
Current boot config : flash:/abc.cfg (file exists)
Backup boot config : flash:/xyz.cfg (file exists)
Software Licenses :
Repository file : ./.configs/.sw_v2.lic
: ./.configs/.swfeature.lic
Certificate file : card:/atmf/nodes/awplus1/flash/.atmf-lic-cert
To Next Page
Loading...
Need help?
General
