Allied Telesis AlliedWare Plus AT-x230-10GP User Manual

480 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
SPANNING TREE COMMANDS
SPANNING
-TREE TRANSMIT-HOLDCOUNT
spanning-tree transmit-holdcount
Overview Use this command to set the maximum number of BPDU transmissions that are
held back.
Use the no variant of this command to restore the default transmit hold-count
value.
Syntax
spanning-tree transmit-holdcount
no spanning-tree transmit-holdcount
Default Transmit hold-count default is 3.
Mode Global Configuration
Example
awplus# configure terminal
awplus(config)# spanning-tree transmit-holdcount

Allied Telesis AlliedWare Plus AT-x230-10GP Specifications

General

Brand	Allied Telesis
Model	AlliedWare Plus AT-x230-10GP
Category	Switch
Language	English