C613-50055-01 REV A Command Reference for x230 Series Edge Switches 245
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
LOGGING COMMANDS
DEFAULT
LOG MONITOR
default log monitor
Overview This command restores the default settings for log messages sent to the terminal
when a terminal monitor command is used.
Syntax
default log monitor
Default All messages are sent to the terminal when a terminal monitor command is used.
Mode Global Configuration
Example To restore the log monitor to its default settings use the following commands:
awplus# configure terminal
awplus(config)# default log monitor
Related
Commands
log monitor (filter)
show log config
To Next Page
Loading...
