122 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
FILE MANAGEMENT COMMANDS
COPY
(FILENAME)
copy (filename)
Overview This command copies a file. This allows you to:
• copy files from your device to a remote device
• copy files from a remote device to your device
• copy files stored on Flash memory to or from a different memory type, such
as an SD card
• create two copies of the same file on your device
Syntax
copy <source-name> <destination-name>
Mode Privileged Exec
Usage The filename and path can include characters from up to four categories. The
categories are:
1) uppercase letters: A to Z
2) lowercase letters: a to z
3) digits: 0 to 9
4) special symbols: all printable ASCII characters not included in the previous
three categories. Including the following characters:
•-
•/
•.
•_
•@
•"
•'
•*
•:
•~
•?
Parameter Description
<source-name> The filename and path of the source file. See Introduction
on page 106 for valid syntax.
<destination-name> The filename and path for the destination file. See
Introduction on page 106 for valid syntax.
To Next Page
Loading...
