Allied Telesis AlliedWare Plus AT-x230-10GP - Show System Pluggable Detail

C613-50055-01 REV A Command Reference for x230 Series Edge Switches 221
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
SYSTEM CONFIGURATION AND MONITORING COMMANDS
SHOW
SYSTEM PLUGGABLE DETAIL
show system pluggable detail
Overview This command displays detailed pluggable transceiver information showing the
pluggable type, the pluggable serial number, and the pluggable port on the
device. Different types of pluggable transceivers are supported in different models
of device. See your Allied Telesis dealer for more information about the models of
pluggables that your device supports.
For information on filtering and saving command output, see “Controlling “show”
Command Output” in the “Getting Started with AlliedWare Plus” Feature Overview
and Configuration Guide.
Syntax
show system pluggable [<port-list>] detail
Mode User Exec and Privileged Exec
NOTE:
In addition to the information about pluggable transceivers displayed using the
show system pluggable command (port, manufacturer, serial number,
manufacturing datecode, and type information), the show system pluggable
detail command displays the following information:
• SFP Laser Wavelength: Specifies the laser wavelength of the installed
pluggable transceiver
• Single mode Fiber: Specifies the link length supported by the pluggable
transceiver using single mode fiber
• OM1 (62.5μ m) Fiber: Specifies the link length (in μm - micron) supported by
the pluggable transceiver using 62.5 micron multi-mode fiber.
• OM2 (50μ m) Fiber: Specifies the link length (in μm - micron) supported by
the pluggable transceiver using 50 micron multi-mode fiber.
Parameter Description
<port-list> The ports to display information about. The port list can be:
• a switch port (e.g. port1.0.9)
• a continuous range of ports separated by a hyphen, e.g.
port1.0.9-1.0.10
• a comma-separated list of ports and port ranges, e.g.
port1.0.9,port1.0.10.