1196 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
AMF COMMANDS
ATMF
MANAGEMENT VLAN
atmf management vlan
Overview The AMF management VLAN is created when the AMF network is first initiated and
is assigned its default VID of 4092. This command enables you to change the VID
from this default value.
The AMF management vlan is one of the internal VLANs that are used to
communicate information about the state of the AMF network between nodes.
AMF uses its internal VLANS (such as the management VLAN and the domain
VLAN) to communicate its inter nodal network status information. These VLANs
must be reserved for AMF and not used for other purposes.
If you assign a VLAN ID to this VLAN (i.e. change its value from the default of 4092)
then you will need to do this separately on every device within the AMF. The AMF
management subnet will then be applied to this new VID when all devices within
the AMF network are next rebooted.
Use the no variant of this command to restore the VID to the default of 4092.
To Next Page
Loading...
Need help?
General
