1444 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
RMON COMMANDS
RMON
EVENT
rmon event
Overview Use this command to create an event definition for a log or a trap or both. The
event index for this event can then be referred to by the rmon alarm command.
Use the no variant of this command to remove the event definition.
NOTE: Only the events for switch port interfaces, not for VLAN interfaces, can be
collected.
Syntax
rmon event <event-index> [description <description>|owner
<owner>| trap <trap>]
rmon event <event-index> [log [description <description>|owner
<owner>|trap <trap>] ]
rmon event <event-index> [log trap [description
<description>|owner <owner] ]
no rmon event <event-index>
Default No event is configured by default.
Mode Global Configuration
Example To create an event definition for a log with an index of 299, use this command:
awplus# configure terminal
awplus(config)# rmon event 299 log description cond3 owner
alfred
To to remove the event definition, use the command:
awplus# configure terminal
awplus(config)# no rmon event 299
Related
Commands
rmon alarm
Parameter Description
<event-index> <1-65535> Unique event entry index value.
log Log event type.
trap Trap event type.
log trap Log and trap event type.
description<description> Event entry description.
owner <owner> Owner name to identify the entry.
To Next Page
Loading...
Need help?
General
