304 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
INTERFACE COMMANDS
SHOW
INTERFACE STATUS
show interface status
Overview Use this command to display the status of the specified interface or interfaces.
Note that when no interface or interfaces are specified then the status of all
interfaces on the device are shown.
Syntax
show interface [<port-list>] status
Examples To display the status of ports 1.0.1 to 1.0.5, use the commands:
awplus# show interface port1.0.1-1.0.4 status
Parameter Description
<port-list> The ports to display information about. The port list can be:
• a switch port (e.g. port1.0.6) a static channel group (e.g. sa2) or
a dynamic (LACP) channel group (e.g. po2)
• a continuous range of ports separated by a hyphen, e.g.
port1.0.1-1.0.6, or sa1-2, or po1-2
• a comma-separated list of ports and port ranges, e.g.
port1.0.1,port1.0.4-1.0.6. Do not mix switch ports,
static channel groups, and dynamic (LACP) channel groups in the
same list
Table 8-2: Example output from the show interface <port-list> status command
awplus#show interface port1.0.1 -1.0.5 status
Port Name Status Vlan Duplex Speed Type
port1.0.1 notconnect 1 auto auto 1000BASE-T
port1.0.2 notconnect 1 auto auto 1000BASE-T
port1.0.3 notconnect 1 auto auto 1000BASE-T
port1.0.4 notconnect 1 auto auto 1000BASE-T
To Next Page
Loading...
