Allied Telesis AlliedWare Plus AT-x230-10GP User Manual

C613-50055-01 REV A Command Reference for x230 Series Edge Switches 989
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
RADIUS COMMANDS
SERVER
(SERVER GROUP)
server (Server Group)
Overview This command adds a RADIUS server to a server group in Server-Group
Configuration mode. The RADIUS server should be configured by the radius-server
host command.
The server is appended to the server list of the group and the order of
configuration determines the precedence of servers. If the server exists in the
server group already, it will be removed before added as a new server.
The server is identified by IP address and authentication and accounting UDP port
numbers. So a RADIUS server can have multiple entries in a group with different
authentication and/or accounting UDP ports. The auth-port specifies the UDP
destination port for authentication requests to the server. To disable
authentication for the server, set auth-port to 0. If the authentication port is
missing, the default port number is 1812. The acct-port specifies the UDP
destination port for accounting requests to the server. To disable accounting for
the server, set acct-port to 0. If the accounting port is missing, the default port
number is 1812.
Use the no variant of this command to remove a RADIUS server from the server
group.
Syntax
server {<hostname>|<ip-address>} [auth-port
<0-65535>][acct-port <0-65535>]
no server {<hostname>|<ip-address>} [auth-port
<0-65535>][acct-port <0-65535>]
Parameter Description
<hostname> Server host name
<ip-address> Server IP address
The server is identified by IP address, authentication and
accounting UDP port numbers. So a RADIUS server can have
multiple entries in a group with different authentication and/or
accounting UDP ports.
auth-port Authentication port
The auth-port specifies the UDP destination port for
authentication requests to the server. To disable authentication
for the server, set auth-port to 0. If the authentication port is
missing, the default port number is 1812.
<0-65535> UDP port number (default: 1812)
acct-port Accounting port
The acct-port specifies the UDP destination port for accounting
requests to the server. To disable accounting for the server, set
acct-port to 0. If the accounting port is missing, the default port
number is 1813.
<0-65535> UDP port number (default: 1813)

Allied Telesis AlliedWare Plus AT-x230-10GP Specifications

General

Brand	Allied Telesis
Model	AlliedWare Plus AT-x230-10GP
Category	Switch
Language	English