932 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plusâ„¢ Operating System - Version 5.4.5-0.x
AUTHENTICATION COMMANDS
SHOW
AUTH-WEB INTERFACE
show auth-web interface
Overview This command shows the status for Web based authentication on the specified
interface, which may be a static channel (or static aggregator) or a dynamic (or
LACP) channel group or a switch port.
Use the optional diagnostics parameter to show authentication diagnostics for
the specified interface. Use the optional sessionstatistics parameter to show
authentication session statistics for the specified interface. Use the optional
statistics parameter to show authentication diagnostics for the specified
interface. Use the optional supplicant (client device) parameter to show the
supplicant state for the specified interface.
Syntax
show auth-web interface <interface-list>
[diagnostics|sessionstatistics|statistics|supplicant [brief]]
Mode Privileged Exec
Example To display the Web based authentication status for port1.0.6, enter the
command:
awplus# show auth-web interface port1.0.6
If web-based authentication is not configured, the output will be
Parameter Description
<interface-list> The interfaces or ports to configure. An interface-list can be:
•an interface (e.g. vlan2), a switch port (e.g. port1.0.6),
a static channel group (e.g. sa2) or a dynamic (LACP)
channel group (e.g. po2)
• a continuous range of interfaces, ports, static channel
groups or dynamic (LACP) channel groups separated by a
hyphen; e.g. vlan2-8, or port1.0.1-1.0.4, or
sa1-2, or po1-2
• a comma-separated list of the above; e.g.
port1.0.1,port1.0.4-1.0.6. Do not mix interface
types in a list
The specified interfaces must exist.
diagnostics Diagnostics.
sessionstatistics Session statistics.
statistics Statistics.
supplicant Supplicant (client device).
brief Brief summary of supplicant state.
% Port-Control not configured on port1.0.6
To Next Page
Loading...
Need help?
General
