Allied Telesis AlliedWare Plus AT-x230-10GP - Default Log Buffered

C613-50055-01 REV A Command Reference for x230 Series Edge Switches 241
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
LOGGING COMMANDS
DEFAULT
LOG BUFFERED
default log buffered
Overview This command restores the default settings for the buffered log stored in RAM. By
default the size of the buffered log is 50 kB and it accepts messages with the
severity level of “warnings” and above.
Syntax
default log buffered
Default The buffered log is enabled by default.
Mode Global Configuration
Example To restore the buffered log to its default settings use the following commands:
awplus# configure terminal
awplus(config)# default log buffered
Validation
Commands
show log config
Related
Commands
log buffered
log buffered size