10
313 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
Switching
Commands
Introduction
Overview This chapter provides an alphabetical reference of commands used to configure
switching.
For more information, see the Switching Feature Overview and Configuration
Guide.
Command List •“backpressure” on page 315
•“clear loop-protection counters” on page 317
•“clear mac address-table static” on page 318
•“clear mac address-table dynamic” on page 319
•“clear port counter” on page 321
•“debug loopprot” on page 322
•“debug platform packet” on page 323
•“duplex” on page 325
•“flowcontrol (switch port)” on page 326
•“linkflap action” on page 328
•“loop-protection” on page 329
•“loop-protection action” on page 331
•“loop-protection action-delay-time” on page 332
•“loop-protection timeout” on page 333
•“mac address-table acquire” on page 334
•“mac address-table ageing-time” on page 335
•“mac address-table static” on page 336
•“mac address-table thrash-limit” on page 337
To Next Page
Loading...
