882 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
AUTHENTICATION COMMANDS
AUTH
-WEB ENABLE
auth-web enable
Overview This command enables Web-based authentication in Interface mode on the
interface specified.
Use the no variant of this command to disable Web-based authentication on an
interface.
Syntax
auth-web enable
no auth-web enable
Default Web-Authentication is disabled by default.
Mode Interface Configuration for a static channel or a switch port.
Usage Web-based authentication cannot be enabled if DHCP snooping is enabled by
using the service dhcp-snooping command, and vice versa. You need to configure
an IPv4 address for the VLAN interface on which Web Authentication is running.
Examples To enable Web-Authentication on static-channel-group 2, use the following
commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# static-channel-group 2
awplus(config-if)# exit
awplus(config)# interface sa2
awplus(config-if)# auth-web enable
To disable Web-Authentication on static-channel-group 2, use the following
commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# static-channel-group 2
awplus(config-if)# exit
awplus(config)# interface sa2
awplus(config-if)# no auth-web enable
Validation
Commands
show auth-web
show auth-web interface
show running-config
Related
Commands
aaa accounting auth-web default
aaa authentication auth-web
To Next Page
Loading...
