230 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
SYSTEM CONFIGURATION AND MONITORING COMMANDS
SPEED
(ASYN)
speed (asyn)
Overview This command changes the console speed from the device. Note that a change in
console speed is applied for subsequent console sessions. Exit the current session
to enable the console speed change using the clear line console command.
Syntax
speed <console-speed-in-bps>
Default The default console speed baud rate is 9600 bps.
Mode Line Configuration
Usage This command is used to change the console (asyn) port speed. Set the console
speed to match the transmission rate of the device connected to the console (asyn)
port on your device.
Example To set the terminal console (asyn0) port speed from the device to 57600 bps, then
exit the session, use the commands:
awplus# configure terminal
awplus(config)# line console 0
awplus(config-line)# speed 57600
awplus(config-line)# exit
awplus(config)# exit
awplus# exit
Then log in again to enable the change:
awplus login:
Password:
awplus>
Parameter Description
<console-speed-in-bps> Console speed Baud rate in bps (bits per second).
1200 1200 Baud
2400 2400 Baud
9600 9600 Baud
19200 19200 Baud
38400 38400 Baud
57600 57600 Baud
115200 115200 Baud
To Next Page
Loading...
Need help?
General
