C613-50055-01 REV A Command Reference for x230 Series Edge Switches 1297
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
MANAGEMENT STACKING COMMANDS
SWITCHPORT
MSTACK-LINK
switchport mstack-link
Overview This command enables you to configure a link to be a management stack link.
Use the no variant of this command to remove any mstack-link that may exist for
the selected link.
Syntax
switchport mstack-link
no switchport mstack-link
Mode Interface Configuration
Usage Running this command will automatically place the port or aggregator into trunk
mode. The link can be a link between switch ports or aggregated ports.
Example To make a switchport a management stack link, use the following commands:
Node_1# configure terminal
Node_1(config)# interface port1.0.1
Node_1(config-if)# switchport atmf-link
To Next Page
Loading...
