804 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
QOS COMMANDS
STORM
-ACTION
storm-action
Overview Sets the action to be taken when triggered by QoS Storm Protection (QSP). There
are three available options:
• portdisable will disable the port in software.
• vlandisable will disable the port from the VLAN matched by the class-map
in class-map.
• linkdown will physically bring the port down. The vlandisable requires the
match vlan class-map to be present in the class-map.
The no variant of this command will negate the action set by the storm-action
command.
Syntax
storm-action {portdisable|vlandisable|linkdown}
no storm-action
Mode Policy Map Class Configuration
Examples To apply the storm protection of vlandisable to the policy-map named
pmap2, and the class-map named cmap1, use the following commands:
awplus# configure terminal
awplus(config)# policy-map pmap2
awplus(config-pmap)# class cmap1
awplus(config-pmap-c# storm-action vlandisable
To negate the storm protection set on the policy-map named pmap2, and the
class-map named cmap1, use the following commands:
awplus# configure terminal
awplus(config)# policy-map pmap2
awplus(config-pmap)# class cmap1
awplus(config-pmap-c# no storm-action
Related
Commands
storm-downtime
storm-protection
storm-rate
storm-window
Parameter Description
portdisable Disable the port in software.
vlandisable Disable the VLAN.
linkdown Shutdown the port physically.
To Next Page
Loading...
