C613-50055-01 REV A Command Reference for x230 Series Edge Switches 817
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
802.1X COMMANDS
DOT
1X EAPOL-VERSION
dot1x eapol-version
Overview This command sets the EAPOL protocol version for EAP packets when 802.1X port
authentication is applied.
Use the no variant of this command to set the EAPOL protocol version to 1.
The default EAPOL protocol version is version 1.
Syntax
dot1x eapol-version {1|2}
no dot1x eapol-version
Default The EAP version for 802.1X authentication is set to 1 by default.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port.
Examples To set the EAPOL protocol version to 2 for port1.0.2, use the commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# dot1x eapol-version 2
To set the EAPOL protocol version to the default version (1) for interface
port1.0.2, use the commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# no dot1x eapol-version
Validation
Commands
show dot1x
show dot1x interface
Parameter Description
1 EAPOL version.
2 EAPOL version.
To Next Page
Loading...
Need help?
General
