1286 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
AMF COMMANDS
SWITCHPORT
ATMF-LINK
switchport atmf-link
Overview This command enables you to configure a port or aggregator to be an AMF
uplink/downlink. Running this command will automatically place the port or
aggregator into trunk mode.
Use the no variant of this command to remove any AMF-link that may exist for the
selected port or aggregated link.
Syntax
switchport atmf-link
no switchport atmf-link
Mode Interface Configuration
Example To make a switchport 1.0.1 an AMF uplink/downlink, use the following commands
Node_1# configure terminal
Node_1(config)# interface port1.0.1
Node_1(config-if)# switchport atmf-link
To Next Page
Loading...
