Allied Telesis AlliedWare Plus AT-x230-10GP - Chapter 28: RADIUS Commands; RADIUS Commands; Introduction

28
976 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
RADIUS Commands
Introduction
Overview This chapter provides an alphabetical reference for commands used to configure
the device to use RADIUS servers.
Command List •“deadtime (RADIUS server group)” on page 977
•“debug radius” on page 978
•“ip radius source-interface” on page 979
•“radius-server deadtime” on page 980
•“radius-server host” on page 981
•“radius-server key” on page 984
•“radius-server retransmit” on page 985
•“radius-server timeout” on page 987
•“server (Server Group)” on page 989
•“show debugging radius” on page 991
•“show radius” on page 992
•“show radius statistics” on page 994
•“undebug radius” on page 995