C613-50055-01 REV A Command Reference for x230 Series Edge Switches 823
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
802.1X COMMANDS
DOT
1X MAX-REAUTH-REQ
dot1x max-reauth-req
Overview This command sets the number of reauthentication attempts before an interface
is unauthorized.
The no variant of this command resets the reauthentication delay to the default.
Syntax
dot1x max-reauth-req <1-10>
no dot1x max-reauth-req
Default The default maximum reauthentication attempts for interfaces using 802.1X port
authentication is two (2) reauthentication attempts, before an interface is
unauthorized.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port.
Usage Use this command to set the maximum reauthentication attempts after failure.
Examples To configure the maximum number of reauthentication attempts for interface
port1.0.2 to a single (1) reauthentication request, use the commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# dot1x max-reauth-req 1
To configure the maximum number of reauthentication attempts for interface
port1.0.2 to the default maximum number of two (2) reauthentication
attempts, use the commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# no dot1x max-reauth-req
Validation
Commands
show running-config
Related
Commands
dot1x max-auth-fail
show dot1x interface
Parameter Description
<1-10> Specify the maximum number of reauthentication attempts for
supplicants on an interface using 802.1X port authentication.
To Next Page
Loading...
Need help?
General
