Allied Telesis AlliedWare Plus AT-x230-10GP - Show Debugging Arp Security

1122 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
DHCP SNOOPING COMMANDS
SHOW
DEBUGGING ARP SECURITY
show debugging arp security
Overview Use this command to display the ARP security debugging configuration.
Syntax
show debugging arp security
Mode User and Privileged Exec
Example To display the debugging settings for ARP security on the switch, use the
command:
awplus# show debugging arp security
Related
Commands
arp security violation
debug arp security
Table 32-8: Example output from the show debugging arp security command
awplus# show debugging arp security
ARP Security debugging status:
ARP Security debugging is off