190 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
SYSTEM CONFIGURATION AND MONITORING COMMANDS
NO
DEBUG ALL
no debug all
Overview This command disables the debugging facility for all features on your device. This
stops the device from generating any diagnostic debugging messages.
The debugging facility is disabled by default.
Syntax
no debug all [dot1x|ipv6|nsm]
Mode Global Configuration and Privileged Exec
Example To disable debugging for all features, use the command:
awplus# no debug all
To disable all 802.1X debugging, use the command:
awplus# no debug all
To disable all IPv6 debugging, use the command:
awplus# no debug all
To disable all NSM debugging, use the command:
awplus# no debug all
Related
Commands
undebug all
Parameter Description
dot1x Turns off all debugging for IEEE 802.1X port-based network access-
control.
ipv6 Turns off all debugging for IPv6 (Internet Protocol version 6).
nsm Turns off all debugging for the NSM (Network Services Module).
To Next Page
Loading...
