C613-50055-01 REV A Command Reference for x230 Series Edge Switches 833
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
802.1X COMMANDS
SHOW
DOT1X INTERFACE
show dot1x interface
Overview This command shows the status of 802.1X port-based authentication on the
specified interface, which may be a static channel (or static aggregator) or a
dynamic (or LACP) channel group or a switch port.
Use the optional diagnostics parameter to show authentication diagnostics for
the specified interfaces. Use the optional sessionstatistics parameter to show
authentication session statistics for the specified interfaces. Use the optional
statistics parameter to show authentication diagnostics for the specified
interfaces. Use the optional supplicant parameter to show the supplicant state for
the specified interfaces.
For information on filtering and saving command output, see “Controlling “show”
Command Output” in the “Getting Started with AlliedWare Plus” Feature Overview
and Configuration Guide.
Syntax
show dot1x interface <interface-list>
[diagnostics|sessionstatistics|statistics|supplicant [brief]]
Mode Privileged Exec
Parameter Description
<interface-list> The interfaces or ports to configure. An interface-list can be:
• an interface (e.g. vlan2), a switch port (e.g.
port1.0.6), a static channel group (e.g. sa2) or a
dynamic (LACP) channel group (e.g. po2)
• a continuous range of interfaces, ports, static channel
groups or dynamic (LACP) channel groups separated by a
hyphen; e.g. vlan2-8, or port1.0.1-1.0.4, or
sa1-2, or po1-2
• a comma-separated list of the above; e.g.
port1.0.1,port1.0.3-1.0.5. Do not mix
interface types in a list
The specified interfaces must exist.
diagnostics Diagnostics.
sessionstatistics Session Statistics.
statistics Statistics.
supplicant Supplicant.
brief Brief summary of supplicant state.
To Next Page
Loading...
