C613-50055-01 REV A Command Reference for x230 Series Edge Switches 1037
AlliedWare Plusâ„¢ Operating System - Version 5.4.5-0.x
LOCAL RADIUS SERVER COMMANDS
USER
(RADIUS SERVER)
user (RADIUS server)
Overview Use this command to register a user to the local RADIUS server.
Use the no variant of this command to delete a user from the local RADIUS server.
Syntax
user <radius-user-name> [encrypted] password <user-password>
[group <user-group>]
no user <radius-user-name>
Mode RADIUS Server Configuration
Usage RADIUS user names cannot contain question mark (?), space ( ), or quote (“ “)
characters. RADIUS user names containing the below characters cannot use
certificate authentication:
/ \ ‘$ &()*;< > ‘|
Certificates cannot be created and exported for RADIUS user names that contain
the above characters. We advise you to avoid using these characters in RADIUS
user names if you need to use certificate authentication, because you will not be
able to create and export certificates.
You also can use the IEEE standard format hexadecimal notation
(HH-HH-HH-HH-HH-HH) to specify a supplicant MAC address to configure the
user name and user password parameters to use local RADIUS server for MAC
Authentication. See the AAA Feature Overview and Configuration Guide for a
sample MAC configuration. See also the command user 00-db-59-ab-70-37
password 00-db-59-ab-70-37 as shown in the command examples.
Parameter Description
<radius-user-name> RADIUS user name. This can also be a MAC address in the
IEEE standard format of HH-HH-HH-HH-HH-HH if you are
configuring MAC authentication to use local RADIUS server.
encrypted Specifies that the password is being entered in its
encrypted form, so that it is not further encrypted.
When creating a new user, enter the password in plaintext,
and do not use the encrypted parameter.
Use the encrypted parameter only when referring to a user
that has previously been created. For instance, when
adding an existing user from another RADIUS server, use
the encrypted parameter, and enter the encrypted version
of the password that appears in the output of show
commands for the user.
<user-password> User password. This can also be a MAC address in the IEEE
standard format of HH-HH-HH-HH-HH-HH if you are
configuring MAC authentication to use local RADIUS server.
group Specify the group for the user.
<user-group> User group name.
To Next Page
Loading...
Need help?
General
