Allied Telesis AlliedWare Plus AT-x230-10GP User Manual

C613-50055-01 REV A Command Reference for x230 Series Edge Switches 1387
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
LLDP COMMANDS
LLDP
RUN
lldp run
Overview This command enables the operation of LLDP on the device.
The no variant of this command disables the operation of LLDP on the device. The
LLDP configuration remains unchanged.
Syntax
lldp run
no lldp run
Default LLDP is disabled by default.
Mode Global Configuration
Examples To enable LLDP operation, use the commands:
awplus# configure terminal
awplus(config)# lldp run
To disable LLDP operation, use the commands:
awplus# configure terminal
awplus(config)# no lldp run
Related
Commands
show lldp

Allied Telesis AlliedWare Plus AT-x230-10GP Specifications

General

Brand	Allied Telesis
Model	AlliedWare Plus AT-x230-10GP
Category	Switch
Language	English