838 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
802.1X COMMANDS
SHOW
DOT1X SESSIONSTATISTICS
show dot1x sessionstatistics
Overview This command shows authentication session statistics for the specified interface,
which may be a static channel (or static aggregator) or a dynamic (or LACP)
channel group or a switch port.
For information on filtering and saving command output, see “Controlling “show”
Command Output” in the “Getting Started with AlliedWare Plus” Feature Overview
and Configuration Guide.
Syntax
show dot1x sessionstatistics [interface <interface-list>]
Mode Privileged Exec
Example See sample output below showing 802.1X (dot1x) authentication session
statistics for port1.0.6:
awplus# show dot1x sessionstatistics interface port1.0.6
Parameter Description
interface Specify a port to show.
<interface-list> The interfaces or ports to configure. An interface-list can be:
•an interface (e.g. vlan2), a switch port (e.g. port1.0.6),
a static channel group (e.g. sa2) or a dynamic (LACP)
channel group (e.g. po2)
• a continuous range of interfaces, ports, static channel
groups or dynamic (LACP) channel groups separated by a
hyphen; e.g. vlan2-8, or port1.0.1-1.0.4, or
sa1-2, or po1-2
• a comma-separated list of the above; e.g.
port1.0.1,port1.0.4-1.0.6. Do not mix interface
types in a list
The specified interfaces must exist.
Authentication session statistics for interface
port1.0.6
session user name: manager
session authentication method: Remote server
session time: 19440 secs
session terminat cause: Not terminated yet
To Next Page
Loading...
