C613-50055-01 REV A Command Reference for x230 Series Edge Switches 519
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
POWER OVER ETHERNET COMMANDS
SERVICE
POWER-INLINE
service power-inline
Overview This command enables Power over Ethernet (PoE) globally on the Power Sourcing
Equipment (PSE) for all PoE ports.
Syntax
service power-inline
no service power-inline
Default PoE functionality is enabled by default on the PSE.
Mode Global Configuration
Examples To disable PoE on the PSE, use the following commands:
awplus# configure terminal
awplus(config)# no service power-inline
To re-enable PoE on the PSE, if PoE has been disabled, use the following
commands:
awplus# configure terminal
awplus(config)# service power-inline
Validation
Commands
show power-inline
show running-config power-inline
To Next Page
Loading...
