886 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
AUTHENTICATION COMMANDS
AUTH
-WEB METHOD
auth-web method
Overview This command sets the authentication method of Web-Authentication that is used
with RADIUS on the interface specified.
The no variant of this command sets the authentication method to PAP for the
interface specified when Web-Authentication is also used with the RADIUS
authentication method.
Syntax
auth-web method {eap-md5|pap}
no auth-web method
Default The Web-Authentication method is set to PAP by default.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port.
Example To set the Web-Authentication method to eap-md5 on interface port1.0.2, use
the following commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# auth-web method eap-md5
Validation
Commands
show auth-web
show auth-web interface
show running-config
Parameter Description
eap-md5 Enable EAP-MD5 as the authentication method.
pap Enable PAP as the authentication method.
To Next Page
Loading...
