520 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
POWER OVER ETHERNET COMMANDS
SHOW
DEBUGGING POWER-INLINE
show debugging power-inline
Overview This command displays Power over Ethernet (PoE) debug settings.
For information on filtering and saving command output, see “Controlling “show”
Command Output” in the “Getting Started with AlliedWare Plus” Feature Overview
and Configuration Guide.
Syntax
show debugging power-inline
Mode User Exec and Privileged Exec
Example To display PoE debug settings, use the following command:
awplus# show debugging power-inline
Output Figure 14-1: Example output from the show debugging power-inline
command
Related
Commands
debug power-inline
terminal monitor
awplus#show debugging power-inline
PoE Debugging status:
PoE Informational debugging is disabled
PoE Event debugging is disabled
PoE Power Management debugging is disabled
PoE NSM debugging is enabled
To Next Page
Loading...
