824 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
802.1X COMMANDS
DOT
1X PORT-CONTROL
dot1x port-control
Overview This command enables 802.1X port authentication on the interface specified, and
sets the control of the authentication port. When port-control is set to auto, the
802.1X authentication feature is executed on the interface, but only if the aaa
authentication dot1x command has been issued.
The no variant of this command disables the port authentication on the interface
specified.
Syntax
dot1x port-control {force-unauthorized|force-authorized|auto}
no dot1x port-control
Default 802.1X port control is disabled by default.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port.
Usage Use this command to force a port state. Note that all dot1x commands can only be
applied to switch ports. They cannot be applied to dynamic (LACP) or static
channel groups.
Examples To enable port authentication on the interface port1.0.2, use the commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# dot1x port-control auto
To enable port authentication force authorized on the interface port1.0.2, use
the commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# dot1x port-control force-authorized
Parameter Description
force-unauthorized Force port state to unauthorized.
Specify to force a port to always be in an unauthorized
state.
force-authorized Force port state to authorized.
Specify to force a port to always be in an authorized state.
auto Allow port client to negotiate authentication.
Specify to enable authentication on port.
To Next Page
Loading...
Need help?
General
