41
1370 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
LLDP Commands
Introduction
Overview LLDP and LLDP-MED can be configured using the commands in this chapter, or by
using SNMP with the LLDP-MIB and LLDP-EXT-DOT1-MIB (see the SNMP MIBs
Overview).
The Voice VLAN feature can be configured using commands in the VLAN
Commands chapter.
For more information about LLDP, see the LLDP Feature Overviewand
Configuration Guide.
LLDP can transmit a lot of data about the network. Typically, the network
information gathered using LLDP is transferred to a Network Management System
by SNMP. For security reasons, we recommend using SNMPv3 for this purpose (see
the SNMP Feature Overviewand Configuration Guide).
LLDP operates over physical ports only. For example, it can be configured on switch
ports that belong to static or dynamic channel groups, but not on the channel
groups themselves.
Command List •“clear lldp statistics” on page 1372
•“clear lldp table” on page 1373
•“debug lldp” on page 1374
•“lldp faststart-count” on page 1376
•“lldp holdtime-multiplier” on page 1377
•“lldp management-address” on page 1378
•“lldp med-notifications” on page 1379
•“lldp med-tlv-select” on page 1380
•“lldp non-strict-med-tlv-order-check” on page 1382
•“lldp notification-interval” on page 1383
•“lldp notifications” on page 1384
To Next Page
Loading...
