C613-50055-01 REV A Command Reference for x230 Series Edge Switches 1231
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
AMF COMMANDS
DEBUG
ATMF PACKET
debug atmf packet
Overview This command configures AMF Packet debugging parameters. The debug only
displays information relevant to the current node. The command has following
parameters:
Syntax
debug atmf packet[[direction {rx|tx|both}][level
{1|2|3}][timeout <seconds>][num-pkts <quantity>][filter node
<name> [interface <ifname>][pkt-type
{[1][2][3][4][5][6][7][8][9][10][11][12][13]]]
Simplified
Syntax
NOTE: You can combine the syntax components shown, but when doing so, you must
retain their original order.
Default Level 1, both Tx and Rx, a timeout of 60 seconds with no filters applied.
NOTE: An alias to the no variant of this command - undebug atmf - can be found
elsewhere in this chapter.
Mode User Exec and Global Configuration
Usage If no additional parameters are specified, then the command output will apply a
default selection of parameters shown below:
debug atmf packet [direction {rx|tx|both}]
[level {[1][2|3}]
[timeout <seconds>]
[num-pkts <quantity>]
debug atmf packet filter [node <name>]
[interface <ifname>]
[pkt-type
[1][2][3][4][5][6][7][8][9][10][11][12][13]]
Parameter Description
direction Sets debug to packet received, transmitted, or both
rx packets received by this node
tx
Packets sent from this node
1 AMF Packet Control header Information, Packet Sequence
Number. Enter 1 to select this level.
2 AMF Detailed Packet Information. Enter 2 to select this level.
3 AMF Packet HEX dump. Enter 3 to select this level.
To Next Page
Loading...
Need help?
General
