Allied Telesis AlliedWare Plus AT-x230-10GP - Show Spanning-Tree Mst Config

424 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
SPANNING TREE COMMANDS
SHOW
SPANNING-TREE MST CONFIG
show spanning-tree mst config
Overview Use this command to display MSTP configuration identifier for the device.
Syntax
show spanning-tree mst config
Mode User Exec, Privileged Exec and Interface Configuration
Usage The region name, the revision number, and the digest of the VLAN to MSTI
configuration table must be the same on all devices that are intended to be in the
same MST region.
Example To display MSTP configuration identifier information, enter the command:
awplus# show spanning-tree mst config
Output Figure 12-6: Example output from the show spanning-tree mst config
command
Related
Commands
instance vlan (MSTP)
region (MSTP)
revision (MSTP)
awplus#show spanning-tree mst config
%
% MSTP Configuration Information:
%------------------------------------------------------
% Format Id : 0
% Name : My Name
% Revision Level : 0
% Digest : 0x80DEE46DA92A98CF21C603291B22880A
%------------------------------------------------------