C613-50055-01 REV A Command Reference for x230 Series Edge Switches 513
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
POWER OVER ETHERNET COMMANDS
POWER
-INLINE ENABLE
power-inline enable
Overview This command enables Power over Ethernet (PoE) to detect a connected Powered
Device (PD) and supply power from the Power Sourcing Equipment (PSE).
The no variant of this command disables PoE functionality on the selected PoE
port(s). No power is supplied to a connected PD after PoE is disabled on the
selected PoE port(s).
Syntax
power-inline enable
no power-inline enable
Default PoE is enabled by default on all ports on the PSE.
Mode Interface Configuration
Usage Select a PoE port, a list of PoE ports, or a range of PoE ports from the preceding
interface (to configure) command. If you specify a range or list of ports they must
all be PoE capable ports.
No PoE log messages are generated for specified PoE port(s) after PoE is disabled.
The disabled PoE port(s) still provide Ethernet connectivity after PoE is disabled.
Examples To disable PoE on ports port1.0.1 to port1.0.4, use the following
commands:
awplus# configure terminal
awplus(config)# interface port1.0.1-port1.0.4
awplus(config-if)# no power-inline enable
To enable PoE on ports port1.0.1 to port1.0.4, use the following
commands:
awplus# configure terminal
awplus(config)# interface port1.0.1-port1.0.4
awplus(config-if)# power-inline enable
Validation
Commands
show power-inline
show power-inline interface
show power-inline interface detail
show running-config power-inline
To Next Page
Loading...
