252 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
LOGGING COMMANDS
LOG
CONSOLE
log console
Overview This command configures the device to send log messages to consoles. The
console log is configured by default to send messages to the devices main console
port.
Use the no variant of this command to configure the device not to send log
messages to consoles.
Syntax
log console
no log console
Mode Global Configuration
Examples To configure the device to send log messages use the following commands:
awplus# configure terminal
awplus(config)# log console
To configure the device not to send log messages in all consoles use the following
commands:
awplus# configure terminal
awplus(config)# no log console
Validation
Commands
show log config
Related
Commands
log console (filter)
To Next Page
Loading...
