C613-50055-01 REV A Command Reference for x230 Series Edge Switches 881
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
AUTHENTICATION COMMANDS
AUTH
-MAC REAUTH-RELEARNING
auth-mac reauth-relearning
Overview This command sets the MAC address learning of the supplicant (client device) to
re-learning for re-authentication on the interface specified in the Interface
command mode.
Use the no variant of this command to disable the auth-mac re-learning option.
Syntax
auth-mac reauth-relearning
no auth-mac reauth-relearning
Default Re-learning for port authentication is disabled by default.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port.
Examples To enable the re-authentication re-learning feature on interface port1.0.2, use
the following commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# auth-mac reauth-relearning
To disable the re-authentication re-learning feature on interface port1.0.2, use
the following commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# no auth-mac reauth-relearning
Validation
Commands
show auth-mac
show auth-mac interface
show running-config
To Next Page
Loading...
