Allied Telesis AlliedWare Plus AT-x230-10GP - Auth-Web-Server Port

908 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
AUTHENTICATION COMMANDS
AUTH
-WEB-SERVER PORT
auth-web-server port
Overview This command sets the HTTP port number for the Web-Authentication server.
Use the no variant of this command to reset the HTTP port number to the default
(80).
Syntax
auth-web-server port <port-number>
no auth-web-server port
Default The Web-Authentication server HTTP port number is set to 80 by default.
Mode Global Configuration
Examples To set the HTTP port number 8080 for the Web-Authentication server, use the
following commands:
awplus# configure terminal
awplus(config)# auth-web-server port 8080
To reset to the default HTTP port number 80 for the Web-Authentication server,
use the following commands:
awplus# configure terminal
awplus(config)# no auth-web-server port
Validation
Commands
show auth-web
show auth-web-server
show running-config
Parameter Description
<port-number> Set the local Web-Authentication server port within the TCP
port number range 1 to 65535.