1326 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
DHCP FOR IPV6 (DHCPV6) COMMANDS
SHOW
COUNTER IPV6 DHCP-CLIENT
show counter ipv6 dhcp-client
Overview Use this command in User Exec or Privilege Exec mode to show DHCPv6 client
counter information.
For information on filtering and saving command output, see “Controlling “show”
Command Output” in the “Getting Started with AlliedWare Plus” Feature Overview
and Configuration Guide.
Syntax
show counter ipv6 dhcp-client
Mode User Exec and Privileged Exec
Example To display the DHCPv6 client counter information, use the command:
awplus# show counter ipv6 dhcp-client
Output Figure 39-1: Example output from the show counter ipv6 dhcp-client
command
awplus#show counter ipv6 dhcp-client
SOLICIT out ......... 20
ADVERTISE in ......... 12
REQUEST out ......... 1
CONFIRM out ......... 0
RENEW out ......... 0
REBIND out ......... 0
REPLY in ......... 0
RELEASE out ......... 0
DECLINE out ......... 0
INFORMATION-REQUEST out ......... 0
Table 39-1: Parameters in the output of the show counter ipv6 dhcp-client
command
Parameter Description
SOLICIT out Displays the count of SOLICIT messages sent by the DHCPv6
client.
ADVERTISE in Displays the count of ADVERTISE messages received by the
DHCPv6 client.
REQUEST out Displays the count of REQUEST messages sent by the DHCPv6
client.
CONFIRM out Displays the count of CONFIRM messages sent by the DHCPv6
client.
RENEW out Displays the count of RENEW messages sent by the DHCPv6
client.
To Next Page
Loading...
Need help?
General
