C613-50055-01 REV A Command Reference for x230 Series Edge Switches 861
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
AUTHENTICATION COMMANDS
AUTH
MAX-SUPPLICANT
auth max-supplicant
Overview This command sets the maximum number of supplicants (client devices) on the
interface that can be authenticated. After this value is exceeded supplicants are
not authenticated.
The no variant of this command resets the maximum supplicant number to the
default (1024).
Syntax
auth max-supplicant <2-1024>
no auth max-supplicant
Default The max supplicant of port authentication is 1024.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port.
Examples To set the maximum number of supplicants to 10 on interface port1.0.2, use
the following commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# auth max-supplicant 10
To reset the maximum number of supplicant to default on interface port1.0.2,
use the following commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# no auth max-supplicant
Validation
Commands
show dot1x
show dot1x interface
show running-config
Parameter Description
<2-1024> Limit number.
To Next Page
Loading...
