1190 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
AMF COMMANDS
ATMF
ENABLE
atmf enable
Overview This command manually enables (turns on) the AMF feature for the device being
configured.
Use the no variant of this command to disable (turn off) the AMF feature on the
member node.
Syntax
atmf enable
no atmf enable
Default Once AMF is configured, the AMF feature starts automatically when the device
starts up.
Mode Global Configuration
Usage The device does not auto negotiate AMF domain specific settings such as the
Network Name. You should therefore, configure your device with any domain
specific (non default) settings before enabling AMF.
Examples To turn off AMF, use the command:
MyNode# config terminal
MyNode(config)# no atmf enable
To turn on AMF, use the command:
MyNode(config)# atmf enable
This command returns the following display:
% Warning: The ATMF network config has been set to enable
% Save the config and restart the system for this change to take
effect.
To Next Page
Loading...
Need help?
General
