1380 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
LLDP COMMANDS
LLDP
MED-TLV-SELECT
lldp med-tlv-select
Overview Use this command to enable LLDP-MED Organizationally Specific TLVs for
transmission in LLDP advertisements via the specified ports. The LLDP-MED
Capabilities TLV must be enabled before any of the other LLDP-MED
Organizationally Specific TLVs are enabled.
Use the no variant of this command to disable the specified LLDP-MED
Organizationally Specific TLVs for transmission in LLDP advertisements via these
ports. In order to disable the LLDP-MED Capabilities TLV, you must also disable the
rest of these TLVs. Disabling all these TLVs disables LLDP-MED advertisements.
Syntax
lldp med-tlv-select {[capabilities] [network-policy] [location]
[inventory-management]}
lldp med-tlv-select all
no lldp med-tlv-select {[capabilities] [network-policy]
[location] [inventory-management]}
no lldp med-tlv-select all
Default By default LLDP-MED Capabilities, Network Policy, Location Identification and
Extended Power-via-MDI TLVs are enabled. Therefore, if LLDP is enabled using the
Parameter Description
capabilities LLDP-MED Capabilities TLV. When this is enabled, the
MAC/PHY Configuration/Status TLV from IEEE 802.3
Organizationally Specific TLVs is also automatically
included in LLDP-MED advertisements, whether or not it
has been explicitly enabled by the lldp tlv-select
command.
network-policy Network Policy TLV. This TLV is transmitted if Voice VLAN
parameters have been configured using the commands:
location Location Identification TLV. This TLV is transmitted if
location information has been configured using the
commands:
inventory-management Inventory Management TLV Set, including the following
TLVs:
• Hardware Revision
•Firmware Revision
• Software Revision
• Serial Number
• Manufacturer Name
•Model Name
• Asset ID
all All LLDP-MED Organizationally Specific TLVs.
To Next Page
Loading...
