Allied Telesis AlliedWare Plus AT-x230-10GP - Page 1381

C613-50055-01 REV A Command Reference for x230 Series Edge Switches 1381
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
LLDP COMMANDS
LLDP
MED-TLV-SELECT
lldp run command, by default LLDP-MED advertisements are transmitted on ports
that detect LLDP-MED neighbors connected to them.
Mode Interface Configuration
Usage LLDP-MED TLVs are only sent in advertisements via a port if there is an
LLDP-MED-capable device connected to it. To see whether there are LLDP-MED
capable devices connected to the ports, use the show lldp neighbors command.
Examples To enable inclusion of the Inventory TLV Set in advertisements transmitted via
ports 1.0.1 and 1.0.6, use the commands:
awplus# configure terminal
awplus(config)# interface port1.0.1,port1.0.6
awplus(config-if)# lldp med-tlv-select inventory-management
To exclude the Inventory TLV Set in advertisements transmitted via ports 1.0.1 and
1.0.6, use the commands:
awplus# configure terminal
awplus(config)# interface port1.0.1,port1.0.6
awplus(config-if)# no lldp med-tlv-select inventory-management
To disable LLDP-MED advertisements transmitted via ports 1.0.1 and 1.0.6, disable
all these TLVs using the commands:
awplus# configure terminal
awplus(config)# interface port1.0.1,port1.0.6
awplus(config-if)# no lldp med-tlv-select all
Related
Commands
lldp tlv-select
location elin-location-id
location civic-location identifier
location civic-location configuration
location coord-location identifier
location coord-location configuration
location elin-location
show lldp interface
switchport voice dscp
switchport voice vlan
switchport voice vlan priority