37
1298 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
NTP Commands
Introduction
Overview This chapter provides an alphabetical reference for commands used to configure
the Network Time Protocol (NTP). For more information, see the NTP Feature
Overview and Configuration Guide.
For information on filtering and saving command output, see “Controlling “show”
Command Output” in the “Getting Started with AlliedWare Plus” Feature Overview
and Configuration Guide.
Command List •“ntp access-group” on page 1299
•“ntp authenticate” on page 1300
•“ntp authentication-key” on page 1301
•“ntp broadcastdelay” on page 1302
•“ntp master” on page 1303
•“ntp peer” on page 1304
•“ntp server” on page 1306
•“ntp source” on page 1308
•“ntp trusted-key” on page 1310
•“show counter ntp” on page 1311
•“show ntp associations” on page 1313
•“show ntp status” on page 1315
To Next Page
Loading...
